Parking Lot Security System using RFID Technology

Radio Frequency Identification RFID technology is widely used in various applications such as attendance system, tracking system, monitoring system or parking system. In this paper, the Parking Lot Security System using RFID technology and embedded technology is presented. In conventional parking system, manual entrance system is applied that permission must be requested from the security guard to access the premise. Therefore, a security guard has to be hired to monitor the premise. In addition, the security guards need to monitor all movement of the vehicle that enters or leave the premise. As a result, the unauthorized vehicle can easily access the premise. To address this problem, the proposed system which can control a vehicle's movement that enters or leave the specific area or place by scanning the RFID tag has been implemented. The potential benefit is it can improve security for both security guards and users. Besides that, this parking system can facilitate access control for users and improve traffic flow and reduce traffic jams. 

by Dr. Thida Aung "Parking Lot Security System using RFID Technology"

Published in International Journal of Trend in Scientific Research and Development (ijtsrd), ISSN: 2456-6470, Volume-3 | Issue-5 , August 2019,

URL: https://www.ijtsrd.com/papers/ijtsrd26512.pdf 

Paper URL: https://www.ijtsrd.com/engineering/electronics-and-communication-engineering/26512/parking-lot-security-system-using-rfid-technology/dr-thida-aung

call for paper Electrical Engineering, international journal Forestry Engineering, ugc approved journals for engineering

Dealing With Reactive Power in Islanded Micro Grid Corresponding Power Distribution in Hierarchical Droop Control using Photovoltaic System

A Micro grid MG is a local energy system consisting of a number of energy sources e.g., wind turbine or solar panels among others , energy storage units, and loads that operate connected to the main electrical grid or autonomously. MGs provide flexibility, reduce the main electricity grid dependence, and contribute to changing large centralized production paradigm to local and distributed generation. However, such energy systems require complex management, advanced control, and optimization. Moreover, the power electronics converters have to be used to correct energy conversion and be interconnected through a common control structure is necessary. A classical droop control system is often implemented in MG. It allows correct operation of parallel voltage sourced converters in grid connection, as well as is landed mode of operation. However, it requires complex power management algorithms, especially in is landed MGs, which balance the system and improves reliability. The novel reactive power sharing algorithm is developed, which takes into account the parameters of the converter as apparent power limit and maximum active power. The developed solution is verified in simulation and compared with other known reactive power control methods. 

by G. Amulya | Dr. S. V. D. Anil Kumar "Dealing With Reactive Power in Islanded Micro Grid-Corresponding Power Distribution in Hierarchical Droop Control using Photovoltaic System"

Published in International Journal of Trend in Scientific Research and Development (ijtsrd), ISSN: 2456-6470, Volume-3 | Issue-5, August 2019,

URL: https://www.ijtsrd.com/papers/ijtsrd26498.pdf 

Paper URL: https://www.ijtsrd.com/engineering/electrical-engineering/26498/dealing-with-reactive-power-in-islanded-micro-grid-corresponding-power-distribution-in-hierarchical-droop-control-using-photovoltaic-system/g-amulya

call for paper Chemical Engineering, international journal Food Engineering, ugc approved journals for engineering

Nonlinear Control of Static Synchronous Compensator STATCOM for Transmission System

The Static Synchronous Compensator STATCOM is a shunt controller, which is a member of FACTS devices. In this paper, an effective and robust controller for STATCOM device on transmission lines, a Single Machine Infinite Bus SMIB system is modeled. A state space mathematical model is constructed which considers both electromechanical oscillations and reactive current of the STATCOM at the installation site. Based the obtained third order model, state feedback linearization and linear quadratic regulation LQR approach are applied to obtain a nonlinear control law. The controllers are simulated and tested under different operating conditions comparing with the conventional PI controller. 

by Yadana Aung | Phyu Phyu Win | Moe Phyu Thel "Nonlinear Control of Static Synchronous Compensator (STATCOM) for Transmission System"

Published in International Journal of Trend in Scientific Research and Development (ijtsrd), ISSN: 2456-6470, Volume-3 | Issue-5, August 2019,

URL: https://www.ijtsrd.com/papers/ijtsrd28002.pdf 

Paper URL: https://www.ijtsrd.com/engineering/electrical-engineering/28002/nonlinear-control-of-static-synchronous-compensator-statcom-for-transmission-system/yadana-aung

call for paper Communication Engineering, international journal Chassis Engineering, ugc approved journals for engineering

Performance of Best Route Selection using RIP and OSPF Routing Protocols

Routing protocols determine the best routes to transfer data from one node to another and specify how routers communicate between each other in order to complete this task. There are different classes of routing protocols, two of which are Exterior Gateway Protocol EGP and Interior Gateway Routing IGR. A routing protocol can be dynamic or static, as well as distance vector or link state. This paper presents the performance of best route selection using dynamic routing protocols such as Routing Information Protocol RIP and Open Shortest Path First OSPF. The network is designed to connect the site A and site B with seven interconnected routers and two switches. The performances of two routing protocols for a wired network are tested and the best route selection has been analyzed with routing table. It can be traced by using tracert command in order to observe the best route between two sites. This performance analysis has been simulated by applying Packet Tracer Simulator. 

by Ma Ma Gyi | San San Naing | Pann Ei San "Performance of Best Route Selection using RIP and OSPF Routing Protocols"

Published in International Journal of Trend in Scientific Research and Development (ijtsrd), ISSN: 2456-6470, Volume-3 | Issue-5, August 2019,

URL: https://www.ijtsrd.com/papers/ijtsrd27873.pdf 

Paper URL: https://www.ijtsrd.com/engineering/electrical-engineering/27873/performance-of-best-route-selection-using-rip-and-ospf-routing-protocols/ma-ma-gyi

call for paper Aerospace Engineering, international journal Chassis Engineering, ugc approved journals for engineering

Implementation of 32 Bit RISC Processor using Reversible Gates

Reversible logic is one of the emerging technologies having promising applications in quantum computing. The aim of this project is to design the schematic and simulation for a 32 bit RISC processor using reversible logic peres gate. Beside the functional development, by optimizing the speed of our processor in every block which is inside that, and to minimize the overall delay conventional gates are replaced with reversible gates. This reversible gates which are applicable in Nano technology, Quantum computing, Low power CMOS, Optical computing. This RISC embodies 15 basic instructions involving Arithmetic, Logical, Data Transfer and control instructions. To implement these instructions the design incorporates various design blocks like Control Unit CU, Arithmetic and Logic Unit ALU, Accumulator, Program Counter PC, Instruction Register IR, Memory and additional logic. Design is implemented and verified in VHDL in Xilinx 14.3. 

by Jyoti Choudhary | Mahesh Kumar Sharma "Implementation of 32-Bit RISC Processor using Reversible Gates"

Published in International Journal of Trend in Scientific Research and Development (ijtsrd), ISSN: 2456-6470, Volume-3 | Issue-5, August 2019,

URL: https://www.ijtsrd.com/papers/ijtsrd26709.pdf 

Paper URL: https://www.ijtsrd.com/engineering/electronics-and-communication-engineering/26709/implementation-of-32-bit-risc-processor-using-reversible-gates/jyoti-choudhary

call for paper Industrial Engineering, international journal Nuclear Engineering, ugc approved journals for engineering

FPGA Based Digital Logic Circuits Operation for Beginners

This paper presents the operations of digital circuits based on FPGA. The long term of FPGA is field programmable gate array. FPGA is an integrated circuit designed to be configured by a customer or a designer after manufacturing  hence field programmable . The operations of logic circuits such as logic gates, flip flop and 7 segment are tested using quartus II software and DE2 115 and DE1 FPGA development kits in this paper. Particularly, there are three main portions such as implementation of schematic diagram, designing of the vhdl program, the connection of the control panel and displaying the result of logic circuits on FPGA kit. The operations of combinational circuits are tested by designing the VHDL programs. And then the operations of sequential circuits are observed and displayed the results of them by illustrating the schematic diagrams. 

by San San Naing | Ni Ni San Hlaing | Cho Thet Nwe "FPGA Based Digital Logic Circuits Operation for Beginners"

Published in International Journal of Trend in Scientific Research and Development (ijtsrd), ISSN: 2456-6470, Volume-3 | Issue-5 , August 2019,

URL: https://www.ijtsrd.com/papers/ijtsrd26372.pdf 

Paper URL: https://www.ijtsrd.com/engineering/electronics-and-communication-engineering/26372/fpga-based-digital-logic-circuits-operation-for-beginners/san-san-naing

call for paper Structural Engineering,  international journal Transport engineering, ugc approved journals for engineering

A Research Article on Synthesis of Metal Nano Particles by Chemical Reduction Method

Nanotechnology is an experimental and engineering technology manipulate at the nanoscale, such as in the field of different compound fabric synthesizing, food processing agriculture processing and as well as in medicinal application. Due to their physical and chemical applications the metal nanoparticles have a great interest in research. A variety of physical, chemical and biological method that can be used for the synthesis of the metal nanoparticle. All the methods have positive advantages as well as some obstruction. In this following review we try to explain recent research on the synthesis and various application of metal nanoparticle. We summarized the different chemical reduction method and briefly explain their application. 

by Vijay Aithekar | Dr. Sangeeta Gautam "A Research Article on Synthesis of Metal Nano Particles by Chemical Reduction Method"

Published in International Journal of Trend in Scientific Research and Development (ijtsrd), ISSN: 2456-6470, Volume-3 | Issue-5 , August 2019,

URL: https://www.ijtsrd.com/papers/ijtsrd26371.pdf 

Paper URL: https://www.ijtsrd.com/physics/nanotechnology/26371/a-research-article-on-synthesis-of-metal-nano-particles-by-chemical-reduction-method/vijay-aithekar


call for paper Environmental Engineering, international journal Food Engineering, ugc approved journals for engineering